This patch finally introduces a small allocation pool
which recycles all the small portions of memory that
are used for headers and pdu structures. This was
the initial idea behind wrapping all memory functions
in libiscsi.
The results of booting are test system up to the login
prompt are quite impressive:
BEFORE:
libiscsi:5 memory is clean at iscsi_destroy_context() after 10712 mallocs, 18 realloc(s) and 10712 free(s)
AFTER:
libiscsi:5 memory is clean at iscsi_destroy_context() after 41 mallocs, 18 realloc(s), 41 free(s) and 10584 reused small allocations
Signed-off-by: Peter Lieven <pl@kamp.de>
Assume target names are URL encoded with '%' as the special character.
Any sequence of '%' followed by two bytes in the target name will be replaced
with the byte that the second two bytes represent in hexadecimal.
Example
iqn.ronnie.test%3A1234
will be translated to iqn.ronnie.test:1234
The code that verifies the pr_type response must compare only the
lower four bits of byte 21 of the response ("TYPE") and must ignore
the upper four bits ("SCOPE").
Signed-off-by: Bart Van Assche <bvanassche@acm.org>
Add a simple test that it works or is not implemented.
Add a RCTD test to verify that with this flag clear we get command descriptors without CTDP set and with it set we get command descriptors with CTDP set and a timeout descriptor
Default to 0 meaning no timeout.
Implement a test for iSCS to test what happens if we send a command
with CMDSN being higher than the target allows.
In this case we dont strictly know what will happen, just that what should
NOT happen is the target responding with success.
But we have to be prepared for any kind of failure, including a timeout,
scsi sense, or even iscsi reject or session failure.
iscsi_data.size is used as parameter to memory
operation functions (such as malloc) which except
size_t rather than int.
Signed-off-by: Peter Lieven <pl@kamp.de>
Add support for BUSY status coide from the target and just pass this
back to the application as is (instead of converting it to _ERROR).
This allows the application to trap task->status==SCSI_STATUS_BUSY and
decide what/how to proceed.
This patch adds support for read/writev to directly read and write
from/to iovectors. Before this patch on read and write from/to socket
the operation was limited by the iovec boundaries. If there is enough
data in the buffer or enough buffer space available its now possible
to transfer the whole data in one atomic operaion.
Signed-off-by: Peter Lieven <pl@kamp.de>
