The test:
"Test WRITESAME16 of 1-256 blocks at the end of the LUN by setting
number-of-blocks==0"
was passing 0 for the data length instead of the block count.
Signed-off-by: Chris Zankel <chris@zankel.net>
Skip 0-block WRITE SAME tests for targets that don't support these
operations, ie. they have write_same_no_zero (WSNZ) set in the
block limits vpd.
Also, fix the test:
"Test WRITESAME10 of 1-256 blocks at the end of the LUN by setting
number-of-blocks==0"
to actually pass 0 blocks instead of the number of remaining blocks to the end.
Signed-off-by: Chris Zankel <chris@zankel.net>
Avoid that Valgrind reports complaints similar to the following:
Syscall param writev(vector[...]) points to uninitialised byte(s)
at 0x5567087: writev (writev.c:49)
by 0x5265AE0: iscsi_iovector_readv_writev (socket.c:492)
by 0x52666B5: iscsi_write_to_socket (socket.c:710)
by 0x5266CCC: iscsi_service (socket.c:852)
by 0x526751F: event_loop (sync.c:67)
by 0x5269B41: iscsi_scsi_command_sync (sync.c:1153)
by 0x4050F6: send_scsi_command (iscsi-support.c:245)
by 0x408007: compareandwrite (iscsi-support.c:1512)
by 0x40B6AD: test_compareandwrite_dpofua (test_compareandwrite_dpofua.c:69)
by 0x503EC99: ??? (in /usr/lib/libcunit.so.1.0.1)
by 0x503EF27: ??? (in /usr/lib/libcunit.so.1.0.1)
by 0x503F2A5: CU_run_all_tests (in /usr/lib/libcunit.so.1.0.1)
Address 0xffeffff10 is on thread 1's stack
in frame #8, created by test_compareandwrite_dpofua (test_compareandwrite_dpofua.c:30)
Signed-off-by: Bart Van Assche <bart.vanassche@sandisk.com>
- writesame10_unmap_until_end, writesame16_unmap, writesame16_unmap_until_end were doing an CU_ASSERT *PER-BYTE* in the verification phase,
which was very CPU-intensive. This change uses memcmp on a whole block which finishes much quicker.
